Search: Cce STILE D3201
Results: 12
Results: 12
Cce STILE D3201 Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
STILE D3201
|
Lamps come on and then go off and the LED on the power supply blinks | Always test whether the pins of capacitors c33 and c29 are leaking, as this will cause the lamps to go out. | ALBERI F S | |
| CCE |
STILE D3201
|
Lamps come on and then go off and the LED on the power supply blinks | Leak in transistor d20 connected to the cap. c33, remove and clean the area and resolder it, in my case it did the trick. | ALBERI F S | |
| CCE |
STILE D3201
|
Turns on and off with sound and image. d21 led flashing | Resolder the terminals of the con1 board next to the d21 led | Medeiros Eletrônica - MG | |
| CCE |
STILE D3201
|
Backlight keeps turning on and off. | The voltage on top of the pcf capacitor was 290v and should have been approx. 380v. | It was moisture residue under the power supply board. All you had to do was clean it with isopropyl alcohol. | Persio (TVCompany) |
| CCE |
STILE D3201
|
Don't care! it only stays on the red LED | Ci u5 1,8v smd na principal | Eletrônica Cecé. Brumadinho MG | |
| CCE |
CCE STILE D3201
|
TV when turned on locks sound channels failing +b U5/U3 ok direct swap EC1/8/4 EC2/11/12 | Replace cap ec1/8/4 2/11/12 | Paulo Souza | |
| CCE |
STILE D3201
MP320G |
LED turns green but does not turn on lamps (backlight) tsound was no voltage of 12 and 24 volts | Diode d7 open: just change it and give the budget. It generates a voltage of 12 volts to power u5 | Replace diode d7 in4007 with a more powerful one. | ELETRONICA SALES.NATAL RN |
| CCE |
STILE D3201
|
The red LED doesn't turn on, press power and it doesn't turn on. 5volts present at the power supply, 12volts absent, pfc does not activate | Change circuit transistors invert q20 to q23 r90a r87. replace q6 in primariod3 r97a and r11 both 10homs, ci pfc defective ci l6562 compatible | ||
| CCE |
STILE D3201
|
Sound like robot disappearing the sound | Replace capacitor next regulator 1.8v ec4 | Replace capacitor ec4 next regulator | Adao da central audio e video |
| CCE |
STILE D3201
|
Orange standby ci invert oscillator warming up but tv won't turn on | Electrolytic ec10 = 220x35 power supply board, electrolytic = 470x16 close l1 regulator u2 main | Replace without testing!!! and good luck! | Jhone eletronica |
| CCE |
STILE D3201
|
TV, turns on, but stops functioning or gives a stuck green screen, that is, processing freezes. | 1.8v smd regulator position u5 on the main board. | In my case I replaced u5 (1.8v) and u3 (3.3v) | MIGUELTV |
| CCE |
STILE D3201
|
TV with sound, screen lights up with no image | Open input fuse on the display strip and shorted ceramic capacitor. | Replace fuse fp1 and capacitor cp46 | TIAGO |