Search: Mitsubishi TC-1410
Results: 9
Results: 9
Mitsubishi TC-1410 Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| MITSUBISHI |
TC-1410
|
LED is on but won't turn on | The cause of the defect was r571 and c567 | Replace of the same | ASSISTEC |
| MITSUBISHI |
TC-1410
1410 |
The power turns on, it stays in stand bay, when you turn it on, the LED goes out | 6r8 3w resistor r571 open and cap c567 shorted on pin 9 line of the flay bak | Replacing the two components solves the problem | pedrinho cachoeirinha |
| MITSUBISHI |
TC-1410
|
The device works but the image shakes (goes back and forth) | Solution. measure the +b on top of the q-551 collector it must have 114 volts if it is above change the photo coupler and go for the hug. | Ademar Videira SC | |
| MITSUBISHI |
TC-1410
|
Vertical slightly open with lines at the top of the screen | R462(22r changed) and c467(100nf ceramic) both connected to pin 5 dp ci451. | Replace the r462 and c467 | jarbas santos |
| MITSUBISHI |
TC-1410
|
TV does not oscillate, press the button to turn it on, the LED goes off and comes on again | Cold solder on pin 10 of the fly back and open 8r2 5w r571 | Resolder and replace the resistor | eletroclaudio aguas belas |
| MITSUBISHI |
TC-1410
|
The TV stays on stand by in power on, the Apga LED but the TV doesn't turn on | It gives the impression that the TV is going to turn on, but the power supply keeps oscillating | On standby measure the voltage on the collector q551 (voltage on standby by 114v dc) any voltage drop on this collector could be a three-component leak (q551, c573 or c572) | Marcio Rossi |
| MITSUBISHI |
TC-1410
|
Vertical slightly open with lines at the top of the screen | R462(22r changed) and c467(100nf ceramic) both connected to pin 5 dp ci451. | Replace the r462 and c467 | jarbas santos |
| MITSUBISHI |
TC-1410
|
TV does not oscillate, press the button to turn it on, the LED goes off and comes on again | Cold solder on pin 10 of the fly back and open 8r2 5w r571 | Resolder and replace the resistor | eletroclaudio aguas belas |
| MITSUBISHI |
TC-1410
|
The TV stays on stand by in power on, the Apga LED but the TV doesn't turn on | It gives the impression that the TV is going to turn on, but the power supply keeps oscillating | On standby measure the voltage on the collector q551 (voltage on standby by 114v dc) any voltage drop on this collector could be a three-component leak (q551, c573 or c572) | Marcio Rossi |