Search:
Results: 87305
Results: 87305
Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
AJ3150
|
Clock advancing, radio sound very low and negative voltage on the capacitors on the radio plate | It was probably just the capacitor that is connected to the crystal, but when in doubt and due to the age of the device, I replaced all the electrolytic capacitors on both plates (13 in total) and it was perfect. | Pedro Igor | |
| PANASONIC |
SA-AKX440
|
Doesn't start. power supplys arm and then disarm | D1001 changed | Replace diode with 1n4007 or equivalent | marcelo lima |
| PHILCO |
PH50A17
|
Audio failing, working intermittently | Solves audio circuits, crystals, phone connector, varicap, hdmis, rcas | Resolder audio circuits, crystals, phone connector, varicap, hdmis, rcas in this case* Lord put your angels sound | |
| LG |
32LJ600B
|
So em stand by | Reflow in the processor successfully resolved | cristiano manutec | |
| LG |
42PN4600
42PN4600 |
Image with pigmentation, clouds | Both 8a60 rescheduled piece | Remove from scrap | JOHNATAN |
| LG |
14CB
|
Almost closed vertical | C311 1000/25 | Fábio boysinnn | |
| PHILIPS |
47PFG7109
TPM14 3L LA |
Without image, tsound is sound. | Burned out leds | Replace the led bars | Eletrônica Moises N.H |
| SONY |
GPX77
|
Error 04 | Burnt outlet | Replace the board or try to do maintenance. Note: if the MOSFETs are toast, I find it very difficult to restore | Stiltec |
| PANASONIC |
SA-MAX9000
|
You have to insist to call, at first it doesn't. | Check pcont on connector cn1851 pin 4 enters the power supply if it is below 2.9v. | Resistor bank rx1003 smd code 101 close to the processor has high resistance in the resistor that plays the pcont signal, replace the rx1003 | Eletrônica Maurício |
| PHILIPS |
43PHG5813
|
No image with LED on | The t-con board does not receive 12v | Fb714 missing, broken or open - from underside of board near panel flat | Alessandro B. Barcelos |
| PHILIPS |
43PHG5813
|
Does not turn on or inoperative | Na main pci see 5v_stb no l701 and less than 5v_sw no c786 is entered | Replace Q706 (aon4421) | Alessandro B. Barcelos |
| PHILIPS |
32PHG5813
|
Does not turn on or inoperative | Na main pci see 5v_stb no l701 and less than 5v_sw no c786 is entered | Replace Q706 (aon4421) | Alessandro B. Barcelos |
| STI |
LC4051FDA
KPS+L150C3 - 01 |
Does not turn on, either manually or with the remote control, the standby LED flashes | Tl431 in position nw905, close to rw903, I put a kia431 in and it worked perfectly again. | Eletrônica HYK | |
| PHILIPS |
32PHG5813
|
If you are going to replace the main board for another size TV of the same phg5813 | Change the u405 memory and the adaptation will work. | Alessandro B. Barcelos | |
| PHILIPS |
32PHG5813/78
|
No image with LED on | The t-con board does not receive 12v | Fb714 missing, broken or open - from underside of board near panel flat | Alessandro B. Barcelos |
| PHILIPS |
AZ1134
|
Cd doesn't play radio fails | POS Function Key (SW1) or (SW7-A) | Function switch replacement or repair | ahunaky |
| LG |
W1642S
|
Doesn't start | Rewrite eeprom | Rewrite eeprom | |
| AOC |
LE24D1440
|
TV completely off, no stand-by, no voltage 3, 3v | U701 with problem (ap3417c) I put one (g5725adjt11u) from a 50" phillips pug6654 the u709 | Tarcisio Brito | |
| SEMP |
LE3973 (A)F
|
Green LED is on and won't turn on | Diode d1 and d2 under the resoudar board | Eletronica Moura | |
| PHILCO |
PTV42G52RCF
|
Does not turn on without standby | Cu 05 capacitor shorted | nildo eletronica bezerros PE |