Search: 14GX
Results: 21
Results: 21
14GX Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
14GX1618 / 78
|
Doesn't start | Transistor 7440 horizontal driver, with cold soldering | MARCONES DE ARARIPINA-PE | |
| PHILIPS |
14GX1515
|
Doesn't start | Power supply plate capacitor 4.7x25v 47x25v | Capacitor | ELETRONICA MAURI JUNIOR |
| PHILIPS |
14GX1618/78R
|
The screen is completely white, full of lines, it's as if the screen were fully open. | R 3469 | Perse | |
| PHILIPS |
14GX1618
|
Doesn't tune in to all off-air channels | R3650 15k | Replacelo | ANTONIO NOBREGA [PATOS.PB] |
| PHILIPS |
14GX1619
|
Inoperative power supply does not arm | Crimping the horizontal output and with very high tension on the altered fly back pacifier | Replace o fly back | eletroclaudio aguas belas pe |
| PHILIPS |
14GX1619
|
White screen with colored retrace lines on the front side and no video | Defective vertical outlet | Replace the same | eletroclaudio aguas belas pe |
| PHILIPS |
14GX1618/78R
ANUBIS VA |
Jagged image | Cap 6531 47/ 160 volts, one of the terminals was corroded, as it is glued, you can't see it, you can only remove it from the board. | jorge mota | |
| PHILIPS |
14GX1618/78R
ANUBIS - VA |
TV doesn't turn on | Led on, only on standby, hcc voltage at 1.95v | Transistor 7423 is good, but when I replaced it, the TV turned on again | odivaldo araujo |
| PHILIPS |
14GX1610
|
Stop without +b | Replace do flay back at 2079/b4 | bt | |
| PHILIPS |
14GX8510 /54R
|
Doesn't start | Open resistor r3561 | ||
| PHILIPS |
14GX1618/78R
|
The screen is completely white, full of lines, it's as if the screen were fully open. | R 3469 | Perse | |
| PHILIPS |
14GX1618
|
Doesn't tune in to all off-air channels | R3650 15k | Replacelo | ANTONIO NOBREGA [PATOS.PB] |
| PHILIPS |
14GX1619
|
Inoperative power supply does not arm | Crimping the horizontal output and with very high tension on the altered fly back pacifier | Replace o fly back | eletroclaudio aguas belas pe |
| PHILIPS |
14GX1619
|
White screen with colored retrace lines on the front side and no video | Defective vertical outlet | Replace the same | eletroclaudio aguas belas pe |
| PHILIPS |
14GX1618/78R
ANUBIS VA |
Jagged image | Cap 6531 47/ 160 volts, one of the terminals was corroded, as it is glued, you can't see it, you can only remove it from the board. | jorge mota | |
| PHILIPS |
14GX1618/78R
ANUBIS - VA |
TV doesn't turn on | Led on, only on standby, hcc voltage at 1.95v | Transistor 7423 is good, but when I replaced it, the TV turned on again | odivaldo araujo |
| PHILIPS |
14GX1610
|
Stop without +b | Replace do flay back at 2079/b4 | bt | |
| PHILIPS |
14GX8510 /54R
|
Doesn't start | Open resistor r3561 | ||
| PHILIPS |
14GX 1618/78R
|
The defect is an all-white screen, full of lines, it's as if the screen is completely open. | Causes open resistor r-3469. check the 180v voltage going to the kinescope board | ||
| PHILIPS |
14GX1618
|
No sound. (with or without image for TV, VCR). | Resistor smd 3801 (2k) sem solda. * 06fev96 anc *. |