×

B7 TV Repair: Common Faults and Solutions.





Search: B7
Results: 45

B7 Repair Guide: Common Issues and Fixes

Repair tips, common issues and fixes.
Brand Model Fault Detailed Problem Solution By
TAICON TAICON B75
Original eeprom data taicon b75 motherboard Original eeprom data taicon b75 motherboard <a href="https://electronica-pt.com/su/q" rel="nofollow" target="_blank">dados da eproom</a> neupsx4
HISENSE H43B7100 RSAG7.820.8752/ROH
Standby LED flashes but the TV does not start and goes to standby When I press the power button it starts blinking normally and then gives 2 quick blinks and goes back to standby. Defective backlight replace the complete bus mario1970
INTELBRáS XNB720VA
Does not hold charge, falls and keeps beeping and turns off power Resistor 100r position r1 Ademar
SAMSUNG UN55B7000
Stand-by LED flashing, but works normally It was solved by changing the two sensor boards (touch and remote)
LG 47LB7DF
Dark screen, no image, lamps do not light. Check f700, open case possible q 706 and q707 shorted, usually cold solder causes them to burn Replace f700, q706, q707 and check possible annealed welds. Assolini BR
LG 47LB7DF
Does not turn on, pfc circuit does not bend 400v. Vcc supply of cis u101 and u600 is low, causing the 400v not to double Shorted components close to u501. Replace of components: zd500 zenner 15v, smd transistor q501 "I took it from scrap from a similar PCI", cracked c509 smd. I didn't find the schematic for this power supply. rafaelmoraes99
LG 42LB7DF
Does not tune dtv channels Ripple in food C817 replace Marcos infotron-ltda
LG 47LB7DF
Does not turn on nor does the LED light up Primary power supply ok! the problem was the shorted pwm u502(ice3b1565j). r508(2r2) open and c202 and 206(2200uf/16v), stewed!. Luir
LG 42LB7DF
Sometimes it turns on, often it doesn't, the LED blinks, activates the inverter but tsound is no image C401 reset circuit open Replace c401 10μF/16 v Roney Nogueira
LG 42LB7DF
Sometimes it turns on but the image stays dark Power transistor 07n60c3 location q706 check q707 too Swapping for a 12n50 power mosfet, solved the problem CELSOKAYRAN
LG 42LB7DF-SB
LJ-81A
Takes time to call Secondary power supply with puffed caps Replace inflated caps on the secondary, c202, c217, c218, c226, c210 and c206, all 105 degrees Romolo Filho
SAMSUNG CCB7571
Monitor
No high voltage C449 - 10µf / 35v Bilico
AOC CMLB747
Monitor
Displacement h when cold. C121 ? 10uf/250v. c12? 47uf/25v. c74? 1uf/250v. c62? 47uf/16v. look for cold welds. Bilico
AOC CMLB746
Monitor
Video flashes in the red cannon. Look for cold sodas. c706, c709 and c711? 1uf/160v. Bilico
LG 47LB7DF
It takes a while to turn on, the LED just keeps blinking C from power supply c202,217,210,221,200 Bruske
SONY FH-B7CD
It doesn't close the drawer (it opens and then doesn't close) and it also doesn't read the CD Check the limit switch on the optical unit, it is usually bent. Straighten the key johnny busnadiego
SONY FH-B7CD
Weak or unlit display Review power supply -24v or diode d 910 = 24v shorted ramiresrc
GOLDSTAR CP14B70
TV does not turn on fluctuations in power supply and low voltage C 828 22/50v located at the power supply ELETRONICA ROCHA
LG 700S -CB777G-NE
Nothing happens (has normal supply voltages) C954 disabled Replace the same with another (1000μF 10v) cardosojp
GOLDSTAR 20B70
The LED turns on, +b low Schism