Search: CM4330
Results: 12
Results: 12
CM4330 Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| LG |
CM4330
CM4330 |
Went into protection when increasing the volume | Aclopador pc902 | Resolved a hug | dinetronic |
| LG |
CM4330
|
Turns on without sound, after a few seconds it goes into protection | 20v zener diode shorted zd905 in front of mosfet q902 | Replace | PATRICK ELETRÔNICA |
| LG |
CM4330
|
Intermittent, sometimes it turns on normally, other times it turns on a squeaky sound and goes into protection! | Altered zd904 diode, in the test it may appear as normal! | Replace without measuring! | Doremilton |
| LG |
CM4330
|
League for 30 seconds enter sprotectio | C726 curto.ao side ci audio | Replace it and it's zero again | George Eletrônica Milênio |
| LG |
CM4330
|
Turns on, reads pen drive without sound and goes into s-protection | Q953 heating up a lot, I put an inverted tip41 and it worked. | Replace | Marcondes Ohm Eletrônica Jaicós PI |
| LG |
CM4330
|
Works for a few minutes and goes into s-protection | Defective pc903 coupler photo | Replace pc903 | SILNEI |
| LG |
CM4330
|
Don't care, power supply ok! When activating the power, you will notice a slight blinking in the LEDs around the vol knob. | Ic701 burst. | Replace ic701, tas5612la. | BRITO |
| LG |
CM4330
|
Doesn't start | Diode d923 | Just replace. | ELETRONICA LINE ORG CICERO LIMA |
| LG |
CM4330
CM |
It turned on, read the pen drive and turned off | After a lot of testing I discovered the transistor q-953 in the test it looked good but the original was open and an ST25c I replaced it with a tip41c | Replace it for another equal one or a tip41c solves it | ELETRÔNICA CAVALCANTE MARTINÓPOLE-CE |
| LG |
CM4330
|
Works for a few minutes, without sound and goes into s-protection | Fotoaclopador | Replace of the same | RAFAEL |
| LG |
CM4330 EAX64991501
|
Sometimes it turns on, sometimes it doesn't. | 6v2 zener diode, position zd902 and 6.8nano polyester capacitor position c908, changed. | Swap 6v2 for 8v2/1w and 6.8nano for 10n/50v and that's it... | LUCIANO ALQUEJA |
| LG |
CM4330
|
Works for a few minutes, then the sound disappears and goes into s-protection | Check the 26v voltage on pin 15 of the cn901 connector, if it varies, check the zd904 10v diode | WILLIAM C.M. |