TP2054 TV Repair: Common Faults and Solutions.

Search: TP2054
Results: 75

TP2054 Repair Guide: Common Issues and Fixes

Repair tips, common issues and fixes.
Brand	Model	Fault	Detailed Problem	Solution	By
PHILCO	TP2054	TV with super expanded image, replaced wide capacitor, but defect persisted, it also contained a vertical, transparent list, the thickness of an index finger on the right end, the globe symbol only appeared as a dot due to the expanded image	All voltages ok, after a lot of analysis, I based it on the schematic, I saw that tsound was an SMD capacitor on the c722 position board, tsound wasn't one on the schematic, so I removed it, and I hugged it, thank God, good luck ..		Otacilio
PHILCO	TP2054	It turned on with a clear image with white lines, as if the screen was completely open, and without characters.	Resistor r714 (4r7 1/2w) , no pino 5 do flay blaeck.	Replace the same. and run to the next repair. I hope I helped my friends.	Bruno Cardoso
PHILCO	TP2054	Sometimes it works and the brightness starts to blink causing these defects with low brightness and when turning on it appears as if it were out of horizontal and vertical frequency wanting to close at the top	Change zener zd 701 zener 8.2v 500mw changed		ricardovideoesom
PHILCO	TP2054	The TV arrived turning on with just a screen full of random spots on the screen and no OSD, during the tests it ended up stopping showing any image, (it wavered and cut out after about 5 s) then the stand-by LED kept blinking.	Ci does everything broken.	Replace the same. (tec.edfesom varjota-ce)	Edfesom
PHILCO	TP2054	I didn't tune the channels, just the good AV didn't pick up any channels	Q201bc337 shorted between base is coleto	I put another bc 337 atv it was good again	Marqueis eltec eletrônico
PHILCO	TP2054	With sound and menu without image	R723 (4k7) smd na linha do abl	I replaced it and it went back to normal	Emanuel (Alfa Eletronica)
PHILCO	TP2054	Generates discharge from the pacifier but does not break	Head of 6n8		Lopestv
PHILCO	TP2054 TP1400	Philco TV does not light up the LED or have any voltage on the secondary power supply	R 911 open it stays in the primary power supply	It was just a matter of changing the resistance r 911, it is in the primary power supply	Jil da Eletrônica
PHILCO	TP2054 TP2053 TP1453	TV has sound, OSD(characters, but the screen is dark "black".	It can be abl or vertical line.	In my case I replaced d602 near the vertical output, tip from elecreplacempos.	eletronica fernandes - to
PHILCO	TP2054	Led on, power button does not activate and +b with 9 volts	Tv is blocked	Turn on via remote control, enter the lock function and deactivate.	samuel leite
PHILCO	TP1454 TP2054	Vertically closed, and turns off with the LED flashing.	Stv9302 e d909 e r910 e r912	After changing the IC, the TV came with a retraced strip on top and the rest of the screen was completely black, the diode was shorted and the two 0.47r resistors were open	Ádrian Chapadão do Céu-Go
PHILCO	TP2054	Vertical doesn't even open, changed all the capacitors in this stage, output ci, ceramic c614 that bothers and ci does everything, nothing solved	Ci voltage regulator 7809 with 1 volt less on the output pin,	Replace and go for the hug	EDGAR THIZ
PHILCO	TP2054	I didn't get normal AV channels	Sf 201	Replace sf 201, and run for the hug	chines eletronica/ solanea PB
PHILCO	TP2054	Inoperative /led blinks weakly with little brightness	Zd906 altered!		orlando lott
PHILCO	TP2054	Didn't turn on the stb	The cracked plate next to the power button	Some jamps were made and the trails were very fine, beautiful	renatosilva
PHILCO	TP2054 00000	Replace r919 everything came back normal	R919 changed, it is not secondary to the power supply	Replace r919 everything came back normal	marcos melo
PHILCO	TP2054	TV stopped doesn't work at all.	C909=4n7 for 2 kv. , short and tsoundfore fusion: toasted.	Both the capacitor and the fuse were replaced and resolved.	Armando de Olimpia Eletronica EvoluSom
PHILCO	TP2054	Screen completely dark with channel sound, menu and character generator working;	The dz701 track was buried	Trail alert	Alextecnico
PHILCO	TP2054	TV doesn't turn on LEDs flashing quickly	D908 inoperative +12v	Replace the memo and everything is ok.	ELETRONICA MONITOR CELSO CAFELANDIA PR
PHILCO	TP2054	I'm sound	Eprom		joao bosco